![]() Open System: MELSOFT Connection (Set this item for each GOT.) Configure the following settings in GX Works2. Set “*” for the host station of only one CPU.Ģ. (4) Set a different station number and IP address for (3) above for each CPU. (For GT Designer3 (GOT2000) Version1.170C or earlier, select → → → from the menu.) ![]() (For GT Designer3 (GOT2000) Version1.178L or earlier, Ethernet (MELSEC), Q17nNC, CRnD-700, Gateway) (For GT Designer3 (GOT2000) Version1.170C or later, Standard I/F(Ethernet): Multi)ĭriver: Ethernet(MITSUBISHI ELECTRIC), Gateway (1) Select → → from the menu.Ĭontroller Type: MELSEC-Q/QS, Q17nD/M/NC/DR, CRnD-700 ◆ For GT Designer3 (GOT2000) Version1.100E or later Configure the following settings in GT Designer3 (GOT2000). The following describes an example of settings to connect a GT27, GT25, or GT21 model (Ethernet connection model) and Ethernet ports built-in multiple QnUDVCPUs by Ethernet.ġ. ・ In the screen gesture mode, the object display is not refreshed.Įthernet connection between the GOT and multiple QnUDVCPUs Note that the following restrictions are applied. GT Designer3 (GOT2000) Version 1.185T or later and GOT Graphic Ver.1, or GT Designer3 (GOT2000) Version 1.112S or later and 1.181P or earlier This setting is available for the following conditions. In addition, to make the drawing process smoother, select –, and then select. To display the screen gesture inactive area on the drawing screen, select –. Touch the key code switch (screen gesture mode switching) placed on the base screen of the GOT. Place a key code switch (screen gesture mode switching) to switch between the screen gesture mode and normal operation mode in the screen gesture inactive area (a 32-dot area from the top edge of the screen).ģ. ◆ GT Designer3 (GOT2000) Version 1.100E or laterġ. Perform the following procedure to use the screen gesture function. “5.2.9 Configuring the security settings for operating the utility and the monitor functions ()” “5.2.10 Configuring the security setting for transferring data ()” “5.2.7 Configuring the security settings for displaying screen data on the GOT ( (Operator authentication))” “5.2.8 Configuring the security settings for displaying screen data on the GOT ( (Level authentication))” GT Designer3 (GOT2000) Screen Design Manual (SH-081220ENG-W) ![]() ・ Setting a password to restrict the utility startup and password setting screen display ・ Setting a password to restrict invalid data reading and writing → Level authentication or operator authentication ・ Setting a password to change the contents of the screen display for each user A password can be set to the rugged model.Ī password can be set to the GOT individually for each case when security is required. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |